USB IMAGE TOOL FOR MAC HOW TO
USB IMAGE TOOL FOR MAC MAC OS X
USB IMAGE TOOL FOR MAC INSTALL

Note that no progress bar is displayed however, to check the status of the operation while it is still running, press Ctrl+t in the terminal. $ sudo dd if=/Users/user_name/Downloads/Flex-Appliance-YYYYMMDD.img of=/dev/rdisk2Ħ. To write the /Users/user_name/Downloads/NB-3.1.2-20180913.img file to the /dev/rdisk2 device, run the following command: $ sudo dd if=/Users/user_name/Downloads/Flex-Appliance-YYYYMMDD.iso of=/dev/rdisk2 To write the /Users/user_name/Downloads/NB-3.1.2-2018093.iso file to the /dev/rdisk2 device, run the following command: Writing an iso or an image to the /dev/ rdisk character device is faster than to the /dev/disk block device.

USB IMAGE TOOL FOR MAC MAC OS X

Note: Mac OS X provides both a block ( /dev/disk) and character device ( /dev/rdisk) file for each storage device. If you enter the wrong disk number, that data cannot be recovered. Running this command deletes all data that is currently on the USB key. Where is the path to the IMG image that you saved, and is the disk number from the previous steps.īe careful to enter the correct disk number. Where is the path to the ISO file that you saved, and is the disk number from the previous steps. Use the dd command as a parameter of the sudo command to write the IMG image to the flash drive, as follows: Where is the disk number from the last command in the previous example, is 2. For example: /dev/disk2, /dev/disk3, etc.ĥ. Run the following command to unmount all the partitions that may have been automounted: Insert your USB flash drive and list the disks again to determine the device node that is assigned to your flash media (for example, /dev/disk2).Ĥ. Open up Terminal.app and type: diskutil listĢ. To verify the USB, you need the truncate utility (also part of the coreutils package), which is also available through Homebrew.ġ.

USB IMAGE TOOL FOR MAC INSTALL

You can install GNU dd (part of the coreutils package) onto a Mac using Homebrew. These instructions work on a Mac using GNU dd or Mac OS dd.

USB IMAGE TOOL FOR MAC HOW TO

For Linux systems, run:Ĭertutil -hashfile Flex-Appliance-YYYYMMDD.iso md5Ĭertutil -hashfile Flex-Appliance-YYYYMMDD.img md5 How to create a Flex USB flash drive from a USB image file on a Mac Replace the file name in these examples with the actual file name of the. Use one of the following commands based upon your operating system to compute the checksum value for the. Be sure to verify that the downloaded release ISO (Flex-Appliance-YYYYMMDD.iso) file MD5 checksum matches the checksum that is contained in the file. NOTE: For models 52, the image file (.img) is not required. NOTE: Be sure to verify that the downloaded release image (Flex-Appliance-YYYYMMDD.img) file MD5 checksum matches the checksum that is contained in the file. User is responsible for conducting all necessary due diligence prior to following the instructions described in this article. Please note that this article references sites not owned or maintained by Veritas and, as such, Veritas is not responsible for the content portrayed on such sites, including any revisions to or deletions of content or third-party software on which this article relies. You can create a bootable USB flash drive using the following instructions. Starting with Flex 2.0, the USB flash drive (aka USB key) is no longer shipped with the Flex appliance.

Usb image tool for mac